EXCERPT FROM THE OS/2 README FILE FOR GA

This is not entirely correct (don't name the file fax.bat, name it something else) but I've
included it because it tells how to do certain WPS operations better than I did.


o   Intel SatisFAXtion
 
    -   The installation program displays the
        message "You have inserted the wrong
        diskette" when changing from disk one to
        disk two.  After the error message is
        displayed, press Enter and the program
        will continue with installation.
    -   At the end of installation of the Intel
        SatisFAXtion you are told to remove the
        diskette and press any key to reboot your
        machine.  Instead, shut down the operating
        system and restart your computer.
    -   If SatisFAXtion software is loaded into
        each DOS session, it might cause the fax
        to stop if another DOS session is started.
        Set up one DOS session to be used for
        faxing, and load the device driver and
        executable files only into that DOS
        session.  To do this, take the following
        steps:
        1.  Edit AUTOEXEC.BAT.
        2.  Cut the last two lines referring to
            the Intel SatisFAXtion board to the
            clipboard and save the file (using DOS
            Command File for the file type).
        3.  Open a New file.
        4.  Paste the last two lines into the new
            file.
        5.  Save the new file as FAX.BAT, using
            DOS Command File as the file type.
        6.  Edit CONFIG.SYS and cut the last two
            lines relating to the Intel
            SatisFAXtion board to the clipboard
            (cut only the last line if you do not
            have a scanner installed).
        7.  Save the file using Plain Text as the
            file type.
        8.  In the Command Prompts folder, select
            a DOS Full Screen icon, press the Ctrl
            key and mouse button two at the same
            time, move the mouse pointer to an
            empty area in the folder, and release
            the mouse button and the Ctrl key.
            This creates a copy of DOS Full
            Screen.
        9.  Put the mouse pointer over your new
            icon and press button two.
        10. Click on the arrow next to Open, and
            select Settings.
        11. Go to the Session page and select the
            DOS settings push button.
        12. Go to DOS_DEVICE and press mouse
            button one.  Move the mouse to the
            dialog area and press button one
            (there should be a blinking cursor
            now).
        13. Paste the text that you cut from the
            CONFIG.SYS file and select Save.
        14. Go to the General page and replace the
            contents of the Title box with FAX (or
            whatever other title you choose).
        15. If you want to edit the new session's
            icon, go to the General page and
            select the Edit push button.
        16. If you want to have this session start
            each time your system starts, move the
            icon to the Start Up folder.
        17. Whenever you start this session, type
            FAX to run the FAX.BAT file before
            using the SatisFAXtion board.
        Use the fax board in only one session at a
        time.
    -   If you install using this procedure and
        you receive error messages, install the
        program under DOS.
